Farming Autonomy Operating System
Field Coverage & Row Planning
Plans every pass, turn and obstacle of a field
Map your field once and the FAOS plans how to cover it row by row, leaving out the areas and obstacles you mark.
How it works
-
01
A Plan for the Whole Field
The FAOS takes your field boundary and generates a complete layout, dividing the area into the core infield and surrounding headland sections, and populating them with passes spaced one working-width apart for full coverage. It then defines the pass sequence for each section, letting you choose whether to work the headland or infield first. Finally, the FAOS generates a continuous, drivable route tailored to your machine’s dimensions, turning radius, and field boundaries.
A field's boundary appears, then its plan draws itself on: headland passes around the edge, the infield filled with passes, and the turns joining them all into one route. -
02
Executing the Plan
Your machine follows the generated route pass by pass across both the headland and the infield until complete field coverage is achieved.
The view dives to a tractor at the field's corner, which sets off along the headland passes. The view then pulls back out over the whole field as the drive speeds up, the covered ground filling in pass by pass until the field is done, with a clock showing the mission time. -
03
Flexible Pass Order
Work the infield passes in a standard, familiar sequential pattern (A), or let the FAOS optimize the order (B) to reduce overall non-working transit between passes. Shorter turns mean lower operational times and costs.
Two plans of the same field side by side, marked A and B. In A, the tractor works the passes in sequence and loops out into the headland to reach the next one. In B, the order is optimised: it skips passes and turns in one shorter arc to a later one. -
04
Custom Headland Layout
Generate a uniform headland around the entire infield perimeter (A), or customize the number of headland passes per boundary edge (B). This reduces the headland footprint without sacrificing the turning room required when working the infield.
Two plans of the same field side by side, marked A and B, draw themselves on. A has a headland three passes deep all around, and its infield passes cover 64% of the field. B has a headland set to suit the field, here deep at the ends and slim along the sides, and its infield passes cover 78%. -
05
Obstacles & Irregular Boundaries
Define the obstacles and no-go zones your machine must avoid. The FAOS adapts the field layout by routing a headland around each obstacle and splitting any intersecting infield passes. Both convex and concave field boundaries are supported.
An irregular field whose edges both bend out and cut in, with a wood in the middle and a small obstacle near one corner, the wood outlined and the small obstacle ringed. As the view sweeps slowly over the field, its plan draws itself on: a headland around each obstacle, passes filling the field around them into every corner, and the turns joining them.